How to order your sleeve

1. Choose your colour

• Single colour: one solid shade for the whole sleeve.
• Dual colour (included with the Dual Density add-on): a natural two-tone look with a lighter head. If you choose black for the shaft, the head is black too.

2. Choose your softness

Silicone softness is measured in Shore. We offer three levels:

• 00-30, Balanced: moderate feel, not too soft or squishy. Also the most durable.
• 00-20, Soft: gentle and flexible, with a noticeable squish.
• 00-10, Very soft: extra squishy and ultra-flexible for maximum softness.

On tackiness: softer silicone naturally feels slightly more tacky. Our process keeps this to a minimum, so it stays as smooth and comfortable as possible while keeping the softness.

3. Add dual density (optional)

• Dual density means one softness for the shaft and a different one for the head.
• For example, a softer head with a firmer shaft, or the other way around.
• Recommended: 00-30 shaft with 00-10 head. It balances durability with a realistic, soft feel at the head.
• Dual colour is included with dual density at no extra cost.

1. Get hard (erect).
2. Stand up while measuring.
3. Measure the top side, not from underneath and not from the balls.
4. Don't press into your fat pad, skin or bone. Measure only the part that sticks out naturally.
5. Measure the part you want the sleeve to cover.

If you're between two sizes, choose the nearest option. Lengths come in 6 mm (¼ in) steps, which gives a precise, comfortable fit.

Measuring width

The inside of the sleeve should be smaller than your penis. That gives a snug, suction-like fit that holds the sleeve in place.

1. Measure your circumference (girth) while fully erect.
2. Wrap a flexible measuring tape around the thickest part, mark where it meets, and note the number.
3. Check a few spots along the shaft and take the average.

Use your average circumference, in centimetres or inches, to choose the internal width in the chart below.